iai.boats

Marine electronics · reviewed November 2026

Boat Electronics Explained: AIS, NMEA Networks and How Big a Battery Bank You Need

A modern boat carries a chartplotter, a VHF radio, a depth sounder, maybe an AIS transponder and an autopilot, and every one of them draws current from the same batteries. This page explains how AIS and the two NMEA data standards work, then gives you a calculator that turns your own device ratings into daily amp-hours and a battery bank size.

Power basics for a boat battery bank

Two formulas do most of the work. Power in watts equals volts times amps, so a 24-watt device on a 12-volt system draws 2 amps. Energy used over time in amp-hours equals amps times hours, so that device uses 48 amp-hours in a day if it runs for 24 hours.

A battery does not give you its full rated amp-hours in everyday use. The share you can use without harming it depends on the battery type, and the data sheet of your battery states it. The calculator below asks you for that figure instead of guessing it. It also divides by the number of days you want to run without charging from the engine, solar panels or shore power.

The wiring, fusing and charging side of a boat's electrical system is a safety matter. Standards bodies such as the American Boat and Yacht Council publish rules for it, and a qualified marine electrician should check any installation.

Daily power use and battery bank calculator

Device
Watts
Hours per day
Enter at least one device with its watts and hours.

Method: daily watt-hours are watts times hours for each device. Amp-hours per day are the total watt-hours divided by system voltage. The bank size is amp-hours per day times the days you need, divided by the usable share as a fraction. Use the watts printed on each device's label or data sheet. The result is a planning figure, and real use also depends on temperature, battery age and charging losses.

Frequently asked questions

What is the difference between AIS Class A and Class B?

Class A transmits at 12.5 watts and reports every 2 to 10 seconds underway, according to the Coast Guard. Class B reports its position less often and at a lower power than Class A.

Is NMEA the same as AIS?

No. NMEA standards define how devices on one boat exchange data. AIS is a radio system that broadcasts a vessel's identity and position to other vessels. An AIS receiver can send its data to a plotter over NMEA.

How do I convert watts to amps on a boat?

Divide the watts by the system voltage. A 60-watt device on a 12-volt system draws 5 amps. On a 24-volt system the same device draws 2.5 amps.

Why does the usable share of the battery matter?

Draining some battery types too far shortens their life. The usable share is the part of the rated amp-hours you plan to draw, so the calculator needs a bank larger than your raw daily use. Your battery's data sheet gives the figure.

About this site

iai.boats is an independent informational site about electronics on boats. It is not an AI service and it sells no boats, parts or services. The AIS figures come from the United States Coast Guard Navigation Center, and the NMEA summary from the NMEA pages named above. Last reviewed: November 2026. Educational content, not professional advice.